



































































































































































































































































Datagest
Software
Gibitre Software
Platform
Smart Test
Identification
RheoCheck
Software
Mooney
Check - Software
Density
Check - Software
Hardness
Check - Software
Tensor
Check - Software
TR_Test -
Software
Brittleness
Check -
Software
PressCheck
Software
Compression
Set -
Software
Company Connection
Software
Gibitre
Software Installer
Maintenance and Calibration Service
ISO 17025 Accredited Calibration
Remote Assistance Service
Support request form



















































































































































































































































































































































Italiano
English
Español
Français
Deutsch
Português
Polskie
Čeština
Magyar
Русский
Türk
中文
日本人
한국어
Arab











































The calculation returns the SHORE Hardness in conformity with ISO 48-4 standard. The Hardness is obtained by measuring the indentation of the indentor after the set test time.
REFERENCE STANDARD: ISO 48-4 / ASTM D 2240
UNIT: Shore point
RESOLUTION: 0.01 Shore
CALCULATION PARAMETERS:
Test Time: t

The calculation returns the angle of the Regression Line of the Hardness-Vs-Time Curve plot in Logarithmic axes.
The angle coefficient provides usefull information about the visco-elastic behavior of the sample during the test. Measures performed on the same product can be used to compare the curing level of different samples or technical parts.
The result is obtained automatically during the standard execution of the hardness test.
UNIT: Shore/sec
RESOLUTION: 0.01 Shore/sec

The calculation returns the Maximum Shore reading at the beginning of the test time.
The Initial hardness has normally a higher value in comparison with the hardness after the set test time.
The result is obtained automatically during the standard execution of the hardness test.
UNIT: Shore
RESOLUTION: 0.01 Shore
REFERENCE STANDARD: ASTM D2240, ISO 48-4


This calculation permits to store the recording of the room temperature measured by the instrument when the test is performed.
Note: the temperature has an important influence on the hardness of rubber and plastic.

This calculation permits to store the recording of the temperature of the sample measured by the instrument when the test is performed. The temperature has an important influence on the hardness of rubber and plastic.

























