Datagest
SoftwareGibitre Software
PlatformSmart Test
IdentificationRheoCheck
SoftwareMooney
Check - SoftwareDensity
Check - SoftwareHardness
Check - SoftwareTensor
Check - SoftwareTR_Test -
SoftwareBrittleness
Check -
SoftwarePressCheck
SoftwareCompression
Set -
SoftwareCompany Connection
SoftwareGibitre
Software InstallerMaintenance and Calibration ServiceISO 17025 Accredited CalibrationRemote Assistance Service
Support request form
Italiano
English
Español
Français
Deutsch
Português
Polskie
Čeština
Magyar
Русский
Türk
中文
日本人
한국어
Arab
When testing material specimens, the accuracy of the results depends directly on the correct entry of the sample’s thickness or cross-sectional area. An inaccurate measurement can compromise the reliability of calculations and mechanical tests.
The thickness gauge integrated with the TensorCheck dynamometer from Gibitre Instruments combines measurement and testing tools into a single solution, making this step fast, accurate, and repeatable.
Thickness measurement is performed in accordance with ISO 23529 and ASTM D3767 standards, meeting all requirements: controlled pressure applied to the specimen, correct indenter geometry, defined number of measurement points, and adequate resolution.
The result is a thickness determination compliant with international standards, immediately available for data processing and laboratory test calculations.
The concrete benefit? A drastic reduction in data entry time, elimination of manual errors, and test procedures standardized to industry standards.
If you’re looking for a solution that integrates thickness measurement directly into the test cycle with TensorCheck, ensuring regulatory compliance and maximum efficiency, this is the ideal choice.
Performing tests on specimens requires the insertion of the thickness or section measurement of the individual specimen for the correct execution of the calculations.
International standards (e.g. ISO 23529 or ASTM D3767) specify:
• Pressure to be applied to the specimen
• Shape of the indenter
• Number of points to measure
• Resolution of the measuring instrument
The feeler gauge integrated with the TensorCheck dynamometer meets the requirements of the standards and drastically reduces the insertion times.
• The dial gauge is mounted directly on the left side of the instrument to facilitate its use.
• Sending data to the software is activated by pressing the 'Enter' button on the main panel of the instrument.
• When all the thickness measurements relating to a specimen have been entered, the 'Next' button on the main panel of the instrument allows you to go to the next specimen without the need to interact with the PC
• The dial gauge has 0.001 mm resolution
• The dial gauge applies the pressure required by the standards to the specimen.
• The comparator tip can be replaced according to the type of specimen and the reference standard.
The instrument can be equipped with a digital thickness gauge for direct insertion of the specimen thickness.
The software:
• Receives the thickness measured in several points
• Calculate the average thickness (or minimum or median according to the norm)
• Calculates the section of the specimen based on the calculation formula defined for the type of specimen in use.
The integration with the thickness gauge allows to insert the section of the whole series of specimens that you have to try in a few seconds.
A thickness gauge version with 50 mm stroke is available to allow the measurement of high thicknesses. The device allows to measure the thickness of specimens in expanded material.
